PowerHome Messageboard: PH Add Full

Active Topics

Memberlist

Help

PowerHome General
PowerHome Messageboard : PowerHome General

Topic: PH Add Full

Author

Message

<< Prev Topic | Next Topic >>

bhlonewolf
Senior Member

Joined: March 29 2007
Online Status: Offline
Posts: 198

Posted: November 18 2009 at 10:28 \| IP Logged

I installed a new keypad and with a few of the buttons, I linked only to the PLM. In PH, I'd then trigger off this via an insteon group in. After I add the link, PH doesn't see any events unless I clear the PLM, and re-add full.

It's not a huge deal because I'm not often changing the links, but thought I'd ask about this and see if anyone else notices this.

If the button is linked to something else (not just the PLM) I can see the traffic just fine...

grif091
Super User

Joined: March 26 2008
Location: United States
Online Status: Offline
Posts: 1357

Posted: November 18 2009 at 13:04 \| IP Logged

The PLM works differently than the old PLC. The PLM requires a responder link for every Group number that PH will trigger from. PLC did not require that detail. Don't know why PH would not write a full responder link in the PLM when the link was created through the Links tab unless perhaps the PLM was originally built with Add Min and that causes PH to think it does not need to write a responder link in the PLM for every Group. I'll run a test tonight and see what happens. Trying to beat the rain this afternoon getting leafs up.

__________________
Lee G

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum