| Author |
|
groston
Newbie
Joined: November 05 2007
Location: United States
Online Status: Offline
Posts: 16
|
| Posted: May 15 2011 at 19:12 | IP Logged
|
|
|
OK - don't laugh. I needed to configure a controller today, ran into a problem, and decided that was sufficient motivation to updated to V2.1b (from 1.03.4.12). Anyway...
Under the old version, one had to jump through a hoop or two to get PH to run as a service. I seem to recall that one of the major upgrades in V2 was the ability to run as a service, however, I could not find any relevant installation and/or usage instructions. Would you please point me to them.
Thanks.
__________________
Gerald P. Roston
gerry (at) pairofdocs (dot) net
|
| Back to Top |
|
| |
rboyleiii
Newbie
Joined: January 15 2008
Location: United States
Online Status: Offline
Posts: 11
|
| Posted: May 15 2011 at 21:36 | IP Logged
|
|
|
I used this post:
How to use (phservice.exe)
HTH
Edited by rboyleiii - May 15 2011 at 21:49
|
| Back to Top |
|
| |
groston
Newbie
Joined: November 05 2007
Location: United States
Online Status: Offline
Posts: 16
|
| Posted: May 15 2011 at 23:33 | IP Logged
|
|
|
I did the same thing - was just wondering if there was some newer information...
__________________
Gerald P. Roston
gerry (at) pairofdocs (dot) net
|
| Back to Top |
|
| |
Active Topics 
Memberlist 
Search 
Help
Register 
Login
PowerHome Messageboard : PowerHome General
Topic: Installing and using PH as a service
